DC Block Frequency 50-3000Mhz
The Silex Splitter has been designed to meet the special needs of the wireless market. It is most commonly used to combine two wireless carriers in the band to a single antenna feed or distribution cable.
- Multiband frequency range
- Minial RF insertion loss
- High reliability
- Very low passive intermodulation(PIM)
- Designed for indoor and outdoor applications
|Item||N Type DC-block|
|Inner conductor minimum isolation capacitance（nF）||1|
|Outer conductor minimum isolation capacitance（nF）||4|
- Radiating System cables
- DC Blocks are coaxial components that prevent the flow of audio and direct current (DC) frequencies while offering minimum interference to RF signals. There are three basic forms of DC blocks. “Inner only” models have a capacitor in series with the center conductor, “outer only” models have a capacitor in series with the outer conductor, and “inner/outer” models have capacitors in series with both the inner and outer conductors. The insulation material on the outer models is non-conductive. Applications include ground loop elimination, signal source modulation leakage suppression, system signal-to-noise ratio improvement, test setup isolation and other situations where undesired DC or audio current flows in the system.
2011/65/EU RoHS Compliant &
Quality Code: SXW10280601H
SilexGlobalSpainSL | The information contained in this document is accurate to the best of our knowledge and representative of the part described herein. It may be necessary to make modifications to the part and/or the documentation of the part, in order to implement improvements. Silex reserves the right to make such changes as required. Unless otherwise stated, all specifications are nominal. More information email@example.com